P0175 System too Rich (Bank 2)

Home » OBD Codes » P0100-P0199 » P0175 System too Rich (Bank 2)

P0175 System too Rich (Bank 2)

Technical Description

System Too Rich (Bank 2)

What does that mean?

This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles. Although generic, the specific repair steps may vary depending on make/model.

Basically this means that an oxygen sensor in bank 2detected a rich condition (too little oxygen in the exhaust). On V6/V8/V10 engines, Bank 2 is the side of the engine that doesn’t have cylinder #1.

Note: This DTC is very similar to P0172, and in fact your vehicle may show both codes at the same time.

Symptoms

You will more than likely not notice any drivability problems, although there may be symptoms such as a misfire.

Causes

A code P0175 may mean that one or more of the following has happened:

  • The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of "oiled" air filters can cause the MAF to become dirty if the filter is over-oiled
  • There could be a vacuum leak.
  • There could be a fuel pressure or delivery problem
  • Possible Solutions

    Possible solutions include:

  • Inspect all vacuum and PCV hoses, replace if necessary
  • Clean the MAF sensor. Consult your service manual for it’s location if you need help. I find it’s best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it’s dry before reinstalling
  • Inspect fuel lines for cracks, leaks, or pinches
  • Check the fuel pressure at the fuel rail
  • Check the fuel injectors, they may be dirty. Use fuel injector cleaner or get them professionally cleaned/replaced.
  • Check for an exhaust leak before the first oxygen sensor (this is unlikely to cause the problem, but it is possible)
  • Need help?

    Let us fix your problem. You are most welcome our diagnosis experts have in most cases the knowledge and skills to find the cause of the error code p0175 and to solve the problems.

    Make an appointment for diagnosis

    "Delete Error Code Permanently, Disable DTC Error Code Function for p0175 in the ECU"

    In extreme cases, we even have the option to permanently remove the specific DTC p0175 and disable the function of the specific error code in the ECU. All other fault code functions will then continue to work to protect the engine. This is different from clearing an error code with a diagnostic device. We have the option to permanently remove the function of the specific error code, so that it never comes back. Also emergency running that occurs on the specific error code can be solved in most cases.

    Of course we prefer to first try to solve the cause of the error code, but sometimes the only solution is to permanently disable the DTC function of p0175.

    Make an appointment for permanent removal of p0175